(888) 644-2876 (815) 338-5800
Migatron Corporation 935 Dieckman St. Woodstock, IL 60098 info@Migatron.com
Description of Pump Up / Pump Down Control
A. When the pump control relay is connected to the normally closed output of the sensor and the container is empty the pump will start up when power is applied. The container will fill until the liquid level rises to the range potentiometer setting.
B. This is the highest level. At this time the sensor output will change state and the pump will shut off. The output will latch in that state until the liquid level descends to the point where the hysteresis potentiometer is set.
C. This is the lowest level. At this point the sensor will change state, turning on the pump and latch until the level rises to the range potentiometer setting again. Then the process repeats.
Pump Down
Wire the pump relay to the normally open contact. This will reverse the process.
Migatron Corp (888) 644-2876
Back To Top^
Migatron Is Your Total Solution For:
Intrinsically Safe Ultrasonic Level Sensors
Explosion Proof Ultrasonic Sensors
Level Control
Ultrasonic Level Sensors
Sonic
Sensors Ultrasonic
Liquid Level Sensors
Tank Level Controls
Precision Measurement Sensor
Level Sensor
Close Range Sensors
Tank Level
Level Sensors
Liquid Level Sensor
Explosion Proof Ultrasonic Sensor
Intrinsically Safe Ultrasonic Level Sensor
Precision Measurement Sensors
Close Range Sensor
Sitemap For more information, please contact us online at info@migatron.com All images and information on this website is copyrighted by Migatron. (888) 644-2876
Website Design By WebItMaster.com
